LABEL LOADING

Label Roll

Socket

Label Feed

Path

Label Door

Label Roll

Mandrel

Width Guide

(Push Down to Adjust)

Cutter Knob

(Pull Forward for Cutting)

Each roll of labels or tape used in the VIPERLS6 is uniquely identified by the mandrel holding the labels. This allows the operating system to automatically set the printer for optimum usage of each label. Also, the operating system keeps track of the remaining labels on each roll. Use steps 1-5 below to load each label roll.

1.Ensure that the printer is turned OFF. If the printer is on, press the

and keys to turn the printer off. Insert the Label Roll into the socket as shown above until it is firmly seated.

2.Ensure that the ribbon knob is in the locked position.

3.Insert the end of the label roll into the label guide path (see yellow arrows). This requires positioning the label width guide to the proper width. IF THE WIDTH GUIDE IS NOT LOCKED INTO A WIDTH

NOTCH, LABEL RECOGNITION FAILURE MAY OCCUR.

4.Labels should be inserted into the label path until resistance is met – approximately ½”.

5.Turn the printer ON. Press the key to position the label for printing.

6.You are now ready to begin printing!

15

Page 15
Image 15
Tamron LS6 quick start Label Loading, NOTCH, Label Recognition Failure MAY Occur