b.The front versus rear of the base are dimensionally alike and interchangeable. The top versus bottom are not.

c.Place square washer from the anchor kit over the studs.

d.If using a regular L-shaped concrete anchor, use a suitable nut and tighten all four corner anchors evenly to 38 ft-lb for ½- in. low-carbon steel studs and fasteners or 83 ft-lb for 3/8-in. hardware.

If using a Telect anchor kit, tighten breakaway torque nut until it shears off plastic-encased holding nut. At shear point, the holding nut will be properly torqued to 60 ft-lb.

e.Remove and save four bolts and washers at top of base.

Washer & Breakaway Nut

From Anchor Kit

Remove 1/2 in. Bolts & Washer Before Setting Cabinet on Base

Either Square Washer From

Anchor Kit or a 1/4-in. Stack of

1/2-in. Fender Washers

Base

Installing a Base Using Telect Model MDC-CBAK Anchor Kit

5.Use the illustration on the right as a guide in designing a two-point lift for moving and placing cabinet over anchors.

ALERT

ALERT! DO NOT STAND BENEATH THE CABINET DURING

LIFTING.

6. After moving cabinet into place over anchors, use the Allen-head-style key to open the doors.

7. Fasten cabinet to base or vault adapter, as shown in the following illus- tration.

If fastening to a base, use the hardware removed in Step 4d.

8.Torque ½ in., low-carbon steel nuts/bolts to 38 ft-lb.

Telect, Inc. • USA +1.509.926.6000 • Mexico +1.52.33.3836.3700

 

Poland +1.48.713.239.100 • UK +1.44.1489.889500 • www.telect.com

Page 2-4

Copyright © 2002 Telect, Inc., All Rights Reserved