Distribution Tie-Down Wall

Feeder Tie-Down Wall

Cable Entrance Dock

Chock Bar

Cover Plates

Preferred Locations of Feeder Cable Clamps

Tie-Down Lance on Feeder Tie-Down Wall

Top View of Cabinet's Rear Floor

4.Use the next illustration to calculate the length of cable(s) required between the splice box (vault or aerial enclosure) and the feeder adapters near the top of the cabinet’s rear compartment. Use heat-shrink tubing to secure the loose tubing at the end of the cable(s).

The illustration shows approximate lengths of exposed subunits/buffers to accommodate the 900 µm fiber between the breakout and the SC/APC connectors. Any breakout length between 15 in. and 50 in. will fit: a short breakout length would place the breakout near the top of the feeder tie-down wall; conversely longer lengths would be tied down closer to the cable entrance.

Feeder Adapters

(Rear Compartment View)

16

9

8

1

Subunit/Buffer Between Breakout and Connector: ~15 in. for Connector 16 to ~25 in. for Connector 1

Subunit/Buffer Between Breakout and Connector: ~40 in. for Connector 16 to ~50 in. for Connector 1

Breakout from Cable to Subunits/Buffers Near Bottom of Rear Compartment

Breakout from Cable to Subunits/Buffers Near Top of Rear Compartment

OSP Feeder Cable From Splice Enclosure (Dressed Out)

Telect, Inc. • USA +1.509.926.6000 • Mexico +1.52.33.3836.3700

 

Poland +1.48.713.239.100 • UK +1.44.1489.889500 • www.telect.com

Page 3-2

Copyright © 2002 Telect, Inc., All Rights Reserved