Each cassette normally accommodates 24 splices. If all feeder and distribution fiber requires splicing, a total of 18 cassettes are needed to accommodate all 432 subscribers. For the distribution splices, each pod would hold 6 splice cassettes plus one additional cassette on one of the pods for up to 16 feeder splices.

Feeder and distribution strands are spliced to connectorized fiber protected by 3-mm, radius control loose tubing. All tubing from the cassettes to the feeder interface and patch modules cross the door hinge near the top of the cabinet. The tubing is anchored along the compartment partition and guided to SC/APC feeder or distribution adapters:

The feeder interface near the top, rear-side of the cabinet contains 16 adapters to pass feeder signals to the front compart- ment splitters.

The distribution adapters are located on 72-port modules (Models MDC-P72N). Fan-out blocks on the Patch Modules are used to accommodate the transition from 3-mm, multi-fiber loose tubing to 900 µm transparent tubes, one for each of the 72 fibers. A total of 6 Patch Modules accommodate the 432 possible subscribers. The SC/APC adapters pass signals to the front compartment for assignment patching.

 

 

Loose Tubing

 

 

 

From Splice

 

 

 

Box to

 

 

 

Rear-Side

 

 

 

Feeder

 

Feeders

 

Adapters

 

 

 

 

Unassigned

 

Loose Tubing

 

Distribution

 

 

 

From Splice Box

 

(Parking)

 

 

 

to Rear-Side

 

 

 

 

 

 

Distribution

 

 

 

Adapters

 

 

 

Fiber Furcated

 

 

 

From 3-mm

 

 

 

Multifiber Loose

 

 

 

Tubing to

 

Assigned

 

900-µmSingle

 

 

Fiber Loose

 

Distribution

 

Tubing

 

to Subscriber

 

 

 

 

 

 

 

Loose Tubing

 

 

 

From Feeder

 

 

 

Cable to Splice

 

 

 

Box

 

 

 

Loose Tubing

 

 

 

From Distribution

 

 

 

Cable to Splice

 

Splitter

 

Box

 

 

 

 

Bulkhead

 

 

 

Splitter Module

2 mm Jumpers

OSP Feeder

OSP Distribution

 

 

Cable From CO

Cable

Front View With Door Open*

Rear View With Door Open*

* Splitter Modules, Patch Modules, Splice Box, Splice Cassettes, Fan-Out Blocks, and Radius-Control Loose Tubing are Sold Separately.

FRONT COMPARTMENT CROSS CONNECTIONS

Front compartment feeder and cross-connect cabling is the same for cabinets with or without in-cabinet splicing.

Each SC/APC adapter at the top of the cabinet serves to feed the fiber signal to a blue jumper in the front compartment. The blue jumper is routed down through the right portion of the front compartment, then around a couple of spools and an arc. The two spools at the bottom route the blue fiber to a Telect Splitter Module.

Telect, Inc. • USA +1.509.926.6000 • Mexico +1.52.33.3836.3700

 

Poland +1.48.713.239.100 • UK +1.44.1489.889500 • www.telect.com

Page 1-5

Copyright © 2002 Telect, Inc., All Rights Reserved