Teledyne 2101 installation and operation guide Connecting to a Site, Field Wizard Operation

2101 Field Wizard Section 3 Operation

3.4 Connecting to a Site

Once you have connected the Field Wizard to Flowlink and set up the initial configuration, you can connect the Field Wizard to a site and retrieve data.

To connect the Field Wizard, refer to the following instructions and to Figure 3-3. For more details and a series of photos showing the connection steps, refer to Section 2.4.

Figure 3-3 Field Wizard Connected to a 2150 Site

The Field Wizard module connects to the top of a 2100 Series stack, which may contain multiple 2100 Series Modules.

1.On the top 2100 Series Module, remove the connector cap from the communication connector and store the cap in its holder.

2.Unlock the Field Wizard’s latch by pressing in on the latch release (right side).

3.Underneath the Field Wizard module, remove the cap from the communication connector and store the cap in its holder.

4.Lock the Field Wizard’s latch by pressing in on the latch on the left side. This correctly seats and aligns the cap in its holder.

5.Position the Field Wizard over the 2100 Series Module. Align the connectors and lower the Field Wizard onto the Module.

6.Unlock the Field Wizard’s latch.

7.Firmly press the modules together and lock the Field Wiz- ard’s latch.

3-6