2101 Field Wizard

Section 2 Preparation and Installation

2.4.2Communication Connecting the Field Wizard module involves uncapping and

Connectors

capping communication connectors. When a communication con-

 

nector is not in use, the connector should always be capped

 

(Figures 2-6 and 2-8). The cap will seal the connector to prevent

 

corrosion, and will improve communications.

 

When a communication connector is in use, store the cap on the

 

holder next to the connector (Figures 2-7 and 2-9). The communi-

 

cation connector will be sealed by its mating connector.

CAUTION

Caps PUSH ON and PULL OFF. Do not rotate the caps to remove them from the connectors.

Capuchons POUSSER et TIRER. Ne pas tourner les capuchons pour les enlever des prises.

Note

For modules to correctly stack and lock together, protective caps between the modules must be stored on the holders.

Figure 2-3:

2100 Series Module’s Upper

Connector - Capped

Figure 2-4:

2100 Series Module’s Upper

Connector - Uncapped

Figure 2-5:

Field Wizard’s Lower

Connector - Capped

Figure 2-6:

Field Wizard’s Lower

Connector - Uncapped

2.4.3 Stacking Modules

To stack a Field Wizard Module on a 2100 Series Module, follow

 

the instructions in Figures 2-10 through 2-17.

2-7

Page 21
Image 21
Teledyne 2101 installation and operation guide Connectors