Teledyne BDS-3960 operating instructions Operation, Vii

Oxygen Analyzer

3.2	Mounting the Analyzer		30
3.3	Rear Panel Connections		32
3.3.1		Gas Connections	32
3.3.2		Electrical Connections	33
	3.3.2.1 Primary Input Power		34
	3.3.2.2 50-Pin Equipment Interface Connector		34
3.4	Electrolyte Refill of BDS Sensor		39
3.5	Testing the System		40
3.6	Powering Up the System		41
Operation		.....................................................................................	42
4.1	Introduction		42
4.2	The Analyzer application		43
4.3	The System Screen		44

4.3.1Communication Information and Calibration Parameters 44

4.3.2Setting Software Parameters: Filter, Gas Factor,

Tmp. Coeff.				45
	4.3.2.1		The Digital Filter	46
	4.3.2.2		The Gas Factor	46
	4.3.2.3		Temperature Coefficient	47
	4.3.2.4		Set Defaults	48
4.4	Calibration of the Analyzer			49
4.4.1		Zero Cal		49
	4.4.1.1		Zero Failure	50
4.4.2		Span Cal		50
	4.4.2.1		Span Failure	51
4.5	The Alarms Function			51
4.6	The Range Function			53
4.6.1		Setting the Analog Output Ranges		53
4.6.2		Fixed Range Analysis		55
4.8	Signal Output			55

Teledyne Analytical Instruments vii