Rear Panel | Teledyne powerpod 400 instruction

6.0 Rear Panel

1.POWER ON/OFF SWITCH

2.POWER INLET & FUSE

3.POWER SELECTOR SWITCH

4.FUSE Vs. POWER SETTING TABLE

5.RS-232 SERIAL PORT CONNECTOR (J6)

6.RS-485, DAISY CHAINED, SERIAL PORT CONNECTORS (J7, J9)

7.TRANSDUCER CONNECTORS (J1-J4)

8.ANALOG OUTPUT (J5)

9.ALARMS (J8)

164-122012 PowerPOD 400

Page 11 of 42

Image 11

Teledyne powerpod 400 instruction manual Rear Panel

Contents

Teledyne Hastings Manual Print History Table of Contents Four to Twenty Milliamp Operation Quick Start Instructions Power Safety Front Panel Lockout Features Power Selection PowerPod-400 Specifications Table Specifications Channel Number Select Keys Front Panel Rear Panel Communications WiringPower Transducer Connections Alarms Analog Signal Followers Override Open Power ON/OFFChanging the Command SET Point Manual Operation Setting a Channel to Display the Totalizer Function Setting a Channel to Auto ControlSetting a Channel to Directly Meter Incoming Signals Mode Reset Value Choosing RS-485 Communication External/Remote OperationChoosing RS-232 Communication Blanking a Display Line/Channel Setup/Cal ModeEntering the SETUP/CAL Mode Display Setup Selecting Gas ID Setting A/D Conversion Rate FilterSelecting Unit-of-Measure Count Up to a Set Point Totalizer SetupFront Panel Lock Out Count Down from a Set Point External Communication SetupRS-232 Settings RS-485 Settings Four to Twenty Milliamp Operation Selecting the Analog Signal LevelZero to Five Volt Operation Zero to Ten Volt Operation Setting a Single Channel’s Hysteresis Setting Limit AlarmsSetting a Single Channel’s High Limit Setting a Single Channel’s Low Limit Enabling Ratio Control Setting Ratio Control Parameters Resetting the Span Only Calibrating a Channel to ITS Incoming SignalsResetting the Zero Only Setting a Multiplication Factor Resetting Zero and Span Set Point Queries CommandsAlarm/Flag Queries Serial Communication PowerPOD Appendix a PowerPod-400 Serial Commands PowerPod-400 Serial Commands Contd Appendix a Notes Name Rate Total ApppendixCB Gas ID Table Page 1 Gas ID Table Page 2 Appendix D Setting the Zero & Span PowerPod-400 Power Supply/Totalizer Zeroing Unit 4 to 20 mA Range Spanning Unit Transducer POWERPOD-400 PowerPOD Drawings Warranty Repair Policy Warranty