Teledyne powerpod 400 instruction manual Appendix a Notes

APPENDIX A (Notes:)

1.All returned values will include decimal points wherever unit has been programmed to display them.

2.All Commands needing decimal points must include them wherever they are intended to be displayed.

3.d = decimal digit (ASCII)

4.n = Channel Number

	⎧Dnd : n = Chnl #				⎫
	⎪	d = 1, Displays Total Units (Mass)			⎪
5.	⎪				⎪
	⎨	d = 2, Displays Flow Units (Rate)			⎬
	⎪				⎪
	⎪	d = 3, Blanks selected channel			⎪
	⎩				⎭
6. rz = range, zero; . rfs = range, full scale
	⎧INnd : n = Chnl #		⎫
	⎪	d = 1, 0 − 5 VDC	⎪
7.	⎪		⎪
	⎨	d = 2, 0 − 10 VDC	⎬
	⎪		⎪
	⎪	d = 3, 4 − 20 mADC	⎪
	⎩		⎭
	⎧TnMd : n = Chnl #
	⎪	d = 1, Totalizer Counts Up, Re sets to Zero
8.	⎪
	⎨	d = 2, Totalizer Counts Down, Re sets to Set Po int
	⎪
	⎪	d = 3, Totalizer Counts Continuously, Re sets to Zero
	⎩
	⎧TFnd : n = Chnl #			⎫
9.	⎪	d = 0, Total < Set Po int		⎪
	⎨			⎬
	⎪	d = 1, Total ≥ Set Po int		⎪
	⎩			⎭

10.text = “OPEN” or “CLOSE” d = 0 or 1

	⎧Rnd : n = Chnl #			⎫
11.	⎪	d = 1 = Enabled		⎪
	⎨			⎬
	⎪	d = 2, Disabled		⎪
	⎩			⎭
12.	⎧BRd :	d = 1, 9600	⎫
	⎨	d = 2, 19200	⎬
	⎩		⎭
13.	⎧REd :	d = 1, LOCAL			⎫
	⎨	d = 2, REMOTE			⎬
	⎩				⎭

⎫

⎪

⎪

⎬

⎪

⎪

⎭

164-122012 PowerPOD 400 Page 32 of 42