Analog Signal Followers | Teledyne powerpod 400 guide

7.5.ANALOG SIGNAL FOLLOWERS

Analog signals from each channel’s transducers are available for reading or for sending to another power supply for ratio (Master/Slave) operation. The signal can be sent to a channel on another power supply and programmed as a Master for that power supply, allowing the remaining three channels to operate as slaves. When operating 4 – 20 mA instruments, the followers supply a 0.5 -2.5 volt signal.

J5	1	Channel 1 Signal
	2	Channel 1 Return
	3	Channel 2 Signal
	4	Channel 2 Return
	5
	6
Analog	7
Analog	8
Out	8
Out	9
(HD DB-15)	9
(HD DB-15)	10
	10
	11	Channel 3	Signal
	12	Channel 3	Return
	13	Channel 4	Signal
	14	Channel 4	Return
	15

164-122012 PowerPOD 400

Page 14 of 42

Image 14

Teledyne powerpod 400 instruction manual Analog Signal Followers

Contents

Teledyne Hastings Manual Print History Table of Contents Four to Twenty Milliamp Operation Power Quick Start Instructions Safety Features Front Panel Lockout Power Selection Specifications PowerPod-400 Specifications Table Front Panel Channel Number Select Keys Rear Panel Communications WiringPower Alarms Transducer Connections Analog Signal Followers Manual Operation Power ON/OFFChanging the Command SET Point Override Open Setting a Channel to Display the Totalizer Function Setting a Channel to Auto ControlSetting a Channel to Directly Meter Incoming Signals Mode Reset Value Choosing RS-485 Communication External/Remote OperationChoosing RS-232 Communication Display Setup Setup/Cal ModeEntering the SETUP/CAL Mode Blanking a Display Line/Channel Selecting Gas ID Setting A/D Conversion Rate FilterSelecting Unit-of-Measure Count Up to a Set Point Totalizer SetupFront Panel Lock Out RS-485 Settings External Communication SetupRS-232 Settings Count Down from a Set Point Zero to Ten Volt Operation Selecting the Analog Signal LevelZero to Five Volt Operation Four to Twenty Milliamp Operation Setting a Single Channel’s Low Limit Setting Limit AlarmsSetting a Single Channel’s High Limit Setting a Single Channel’s Hysteresis Setting Ratio Control Parameters Enabling Ratio Control Resetting the Span Only Calibrating a Channel to ITS Incoming SignalsResetting the Zero Only Resetting Zero and Span Setting a Multiplication Factor Serial Communication CommandsAlarm/Flag Queries Set Point Queries PowerPOD PowerPod-400 Serial Commands Appendix a PowerPod-400 Serial Commands Contd Appendix a Notes ApppendixCB Name Rate Total Gas ID Table Page 1 Gas ID Table Page 2 Setting the Zero & Span PowerPod-400 Power Supply/Totalizer Appendix D Zeroing Unit 4 to 20 mA Range Spanning Unit Transducer POWERPOD-400 PowerPOD Drawings Warranty Warranty Repair Policy