Specifications | Teledyne powerpod 400 guide

4.0 Specifications

PowerPod-400 Specifications Table

	Specification	Value			Units		Notes
	Power Inputs
		100					0.7 A, 250VAC, SB Fuse
	V	115			VAC		0.6 A, 250VAC, SB Fuse
		230					0.315 A, 250VAC, SB Fuse
	P	68			VA
	f	50 -60			Hz

	Transducer
	Number Channels	4
	VSupply	±15			VDC		Bi-polar, per Channel
	ISupply	±250			mA		Bi-polar, per Channel
		0 - 5			VDC
	I/O	0 - 10			VDC
	I/O	0 - 10
		4 - 20			mADC

	Display
	Type						Vacuum Fluorescent,
	Type						LCD Emulator
							LCD Emulator
	# Lines	4
	# Characters	20
	Brightness Levels	4

	A/D Converter
	Filtering Rate	4, 15, 30,			Hz
		100			Hz
		100


	Alarms
	3 per channel	1 High
		1 Low
		1 Total

	Dimensions
	Front Panel (h x w)	3.5 x 9.5			in
	Case (h x w x d)	3 x 8 x 9.5			in
	Hole Centers (h x	3 x 8.825			in
	w)

	Weight	5 1/4			lbs

164-122012 PowerPOD 400

Page 9 of 42

Image 9

Teledyne powerpod 400 instruction manual PowerPod-400 Specifications Table

Contents

Teledyne Hastings Manual Print History Table of Contents Four to Twenty Milliamp Operation Quick Start Instructions Power Safety Front Panel Lockout Features Power Selection PowerPod-400 Specifications Table Specifications Channel Number Select Keys Front Panel Rear Panel Wiring PowerCommunications Transducer Connections Alarms Analog Signal Followers Changing the Command SET Point Power ON/OFFManual Operation Override Open Setting a Channel to Auto Control Setting a Channel to Directly Meter Incoming SignalsSetting a Channel to Display the Totalizer Function Mode Reset Value External/Remote Operation Choosing RS-232 CommunicationChoosing RS-485 Communication Entering the SETUP/CAL Mode Setup/Cal ModeDisplay Setup Blanking a Display Line/Channel Setting A/D Conversion Rate Filter Selecting Unit-of-MeasureSelecting Gas ID Totalizer Setup Front Panel Lock OutCount Up to a Set Point RS-232 Settings External Communication SetupRS-485 Settings Count Down from a Set Point Zero to Five Volt Operation Selecting the Analog Signal LevelZero to Ten Volt Operation Four to Twenty Milliamp Operation Setting a Single Channel’s High Limit Setting Limit AlarmsSetting a Single Channel’s Low Limit Setting a Single Channel’s Hysteresis Enabling Ratio Control Setting Ratio Control Parameters Calibrating a Channel to ITS Incoming Signals Resetting the Zero OnlyResetting the Span Only Setting a Multiplication Factor Resetting Zero and Span Alarm/Flag Queries CommandsSerial Communication Set Point Queries PowerPOD Appendix a PowerPod-400 Serial Commands PowerPod-400 Serial Commands Contd Appendix a Notes Name Rate Total ApppendixCB Gas ID Table Page 1 Gas ID Table Page 2 Appendix D Setting the Zero & Span PowerPod-400 Power Supply/Totalizer Zeroing Unit 4 to 20 mA Range Spanning Unit Transducer POWERPOD-400 PowerPOD Drawings Warranty Repair Policy Warranty