Firgure A-1. Sliding the Module into the Card Guides

Appendix A

8-Port Expansion Module Option

3.Insert the cable clip into the round hole next to the relays labeled K2 and K3 on the component side of the Module. Use this cable clip to route and arrange cables within the OMEGA unit.

4.Hold the Module vertically above the card guides, so its 8 RJ- 11 jacks are at the top and facing toward the inside of

OMEGA.

5.Insert the Module into the card guide slots and slide it down until the male connector engages fully into the female connector on the OMEGA baseboard (see Figure A-1). This installation can only be made one way. If you are not successful with your first try, turn around the Module and try again.