Telenetics OM-AMPS-100 manual Connecting the Endpoint Device

Section 1 Contents

Figure 1-4. Connecting an Input Voltage Source

4.Secure the ground wires by tightening the screws located in the small holes of the AC fuse connectors, as shown above.

Connecting the Endpoint Device

To connect an endpoint device to OMEGA:

1.Insert the modem cable from the endpoint device through the conduit hole at the bottom of the compartment.

2.If the OMEGA 8-Port Line-Sharing Module is not installed, connect the cable to the single RJ-11 jack located near the conduit hole (see Figure 1-1 on page 13). Otherwise, refer to the OMEGA 8-PortLine-Sharing Module Quick Start Guide (Telenetics part number 0049-0706-001).

20 OMEGA Installation, Operation, and Maintenance Manual