Telenetics OM-AMPS-100 manual Call Answer Testing

Section 1 Contents

and the one after it to test OMEGA’s ability to originate and answer calls.

IMPORTANT: If reception is poor, place the cover on OMEGA to shield the transmission from radiating energy to the transceiver.

To test OMEGA’s ability to originate a call:

1.Disconnect the external modem from the OMEGA RJ-11 modem jack.

2.Connect a standard telephone to the OMEGA RJ-11 modem jack. This jack is located on the side opposite the cellular transceiver connector (see Figure 1-1 on page 13).

3.Use the telephone to dial a call. If you make a connection, it indicates that the OMEGA cellular transceiver can originate calls.

NOTE: The modem that came with the endpoint device may provide additional ways to test the modem’s dial-out capabilities. Refer to the manual that came with the modem for more information.

Call Answer Testing

To test OMEGA’s ability to answer a call:

1.With the telephone connected to the OMEGA modem RJ-11 jack, use another telephone to call OMEGA. The telephone attached to OMEGA should ring.

2.Remove the telephone and reconnect the endpoint device to the modem jack connection on OMEGA. Have a remote modem call OMEGA. The modem connected to OMEGA should answer the call automatically.

If the modem fails to automatically answer the calls, make sure the modem used with the endpoint device is configured for auto- answer (refer to the manual that came with the modem for more information).

OMEGA Installation, Operation, and Maintenance Manual 23