Telex Q II - FOH specifications Dir

AUX 1 (Upper control)

Controls the level of the channel signal fed to the Aux 1 bus. This signal is normally post-fader, unless the PRE button, just below, is depressed. Internal links on the module pcb allow the pre-fader feed to be pre or post-EQ (paired with Aux 2).

AUX 2 (Lower control)

Controls the level of the channel signal fed to the Aux 2 bus. This signal is normally post-fader, unless the PRE button, just below, is depressed.

PRE

Selects the signal feed for Auxes 1 and 2 to be pre-fader rather than post-fader.

AUX 3 (Upper control)

Controls the level of the channel signal fed to the Aux 3 bus. This signal is normally post-fader, unless the PRE button, just below, is depressed. Internal links on the module pcb allow the pre- fader feed to be pre or post-EQ (paired with Aux 4).

AUX 4 (Lower control)

Controls the level of the channel signal fed to the Aux 4 bus. This signal is normally post-fader, unless the PRE button, just below, is depressed.

PRE

Selects the signal feed for Auxes 3 and 4 to be pre-fader rather than post-fader.

DIR

Re-routes the signal on the Aux 4 control to feed the Channel Direct output. The signal no longer feeds the Aux 4 bus, and can be used either as an additional single effects send, or as a feed to a multitrack for example.

Note: Dir and Pre are local to the module, they do not affect the signal flow on any other module than the one on which they are located.

Q2 OPERATIONAND MAINTENANCE MANUAL 9601 23