Limitorque MX DeviceNet Field Unit FCD
4.6.2View Settings
Refer to Bulletin LMAIM1306/2306, MX Installation and Operation Manual to access the “VIEW SETTINGS” menu. Verify the settings as follows:
5 View DeviceNet Status
Figure 5.1 – DeviceNet Screens
YES
YES
YES
YES
YES
YES | YES | YES |
CHANGE | STATUS |
| BAUD RATE | DNET ADDRESS | ANALOG SCALE | CHANGE PROP | PROP BAND | DEADBAND | |||||
DEVICENET? | NET | DEAD BAND? | (2%) |
| |||||||||
NO | (ON) | NO | (125K) | NO | NO | NO | NO | NO | NO | ||||
|
|
|
|
|
|
|
| ||||||
|
|
| (250K) |
|
|
|
|
|
|
|
|
| |
|
|
| (500K) |
|
|
|
|
|
|
|
|
|
|
|
|
| (NET CTRL) |
|
|
|
|
|
|
|
|
|
|
|
| YES |
|
|
| YES |
|
|
|
| YES |
ESD ACTION |
|
|
| COMM LOSS ACTION |
|
|
| COMM LOSS DELAY | |||
|
|
|
|
|
| (60 | |||||
| NO | * |
| YES |
| NO | * |
| YES |
| NO |
(CLOSE) |
|
| (CLOSE) |
|
| ||||||
|
|
|
|
|
|
|
|
| |||
(OPEN) |
|
| MOVE TO | (OPEN) |
|
| MOVE TO |
|
| ||
(STOP) |
|
| (STOP) |
|
|
|
| ||||
(POSITION) |
|
| XXX% OPEN | (POSITION) |
|
| XXX% OPEN |
|
| ||
|
|
| NO |
|
|
| NO |
|
| ||
|
|
|
|
|
|
|
|
|
| ||
*If POSITION is chosen, as action, this menu will appear.
36
VIEW DNET STATUS?
This selection permits the User to view pertinent information which summarizes the status of the DeviceNet option board.
VIEW MODULE STATUS?
• Answer "YES" to determine status of individual DN board within the actuator.
• Configuration choices are:
• "OFF" = board installed but turned off
• “OPERATIONAL” – The device is operating in a normal condition.
• "STANDBY" = The device needs commissioning due to configuration missing, incomplete or incorrect.
• "RECOVERABLE FAULT" = Conditions that can cause this event are e.g. communication fault, power fault or Limigard fault of the SMT Main Board. Device may need resetting.
• "UNRECOVERABLE FAULT" = Internal Diagnostic Fault detected e.g.
• Receive Queue Overrun
• Transmit Queue Overrun
• CAN Controller Overrun
• Device may need replacing.
• "SELF TESTING" = The device is in
VIEW NETWORK STATUS?
Answer “YES” to determine status of DN network.
• "NOT ON LINE" = Device is not
