Toshiba 210C manual Bypass Copying on Standard Size or A3-wide Paper, Perform steps 1 to 2 on

Bypass Copying on Standard Size or A3-wide Paper

1	Perform steps 1 to 2 on page 6-6.
	Set the “OTHER” size key as necessary Page 6-15

If the paper that has been set is the standard size other than A3, A4, B4 or B5, you will select the OTHER key in step 4. In this case, you need to make the OTHER key recognize the same size as the paper that has been set. Such setting should be done at this step.

2 Press the PROGRAM key to enter the programme menu, and press the BYPASS FEED key.

- When paper is set on the sheet bypass, pressing the by-

pass guide icon as shown on the right-hand display can also make the screen in step 3 appear.

3 After selecting the paper type key corresponding to the type of the paper that has been set, press the SET key.

-Plain paper is selected as the default mode (half-tone shaded).

-When using A3-wide paper, press both the paper weight key and the 305x457mm key. Then press the SET key.

4 Select the key of the same size as the paper that has been set.

- For A3-wide paper, the selection is done in step 3.

- For A4-R (or B5-R) size, press the A4 (or B5 ) key twice.

- OTHER key Page 6-15

If the size of the sheets fed from the sheet bypass is not speci- fied, the Automatic Magnification Selection mode is cancelled.

Select other copy modes as required.

5 Press the START key.

6

6-7