15
G8000 Series Installation and Operation Manual
6.1 Warning Label Locations
FIGURE 6.2 – 100 KVA UPS WARNING LABELS
DANGER
Hazardous voltages are used in the operationof this equipment and could cause severe personalinjury or loss of life.The following precautions should be observed toreduce the risk of injury or death.HAZARDOUS VOLTAGESOnly qualified technicians familiar with this equipment and the information supplied with it should be permitted to install and operate this equipment.Installation of electrical equipment must be done inaccordance with National Electrical Code and any other stateor local codes. Proper grounding and conductor sizing must be installed for safe operation.During operation, keep all covers in place and cabinetdoors shut.When performing visual inspections and maintenance, if possible, be sure the UPS is turned off and the incoming AC feed is turned off and locked out. If it is nece ssary to make measu remen ts with the po weron, do not touch any electrical connection points. Removeall jewelry from wri sts and fing ers. Make s ure test equipment is in good, safe operating condition.While servicing, stand on some type of insulation, and be sure not to be grounded.Follow the safety instructions given in the equipment manualcarefully and observe all danger, warning and caution notices.
40308
The UPS and Battery Cabinet will have hazardous voltages present even after the AC feed is turned off.DANGERAC VOLTA GEThis UPS receives power from mor e than one source. Disconnect all AC sources before performing any serviceor testing inside this unit
48082
2
V
3
W
4
U
REFER TO INSTRUCTION MANUAL FOR WIRE SIZE AND TIGHTENING TORQUE
480V
AC INPUT
480V
BYPASS INPUT
1
U
480V
AC OUTPUT
400V
BATTERY
5
V
6
W
7
N
8
U
9
V
10
W
11
N
USE COPPER CONDUCTORS ONLY!12 13-+
(B) 40308(A) 48082
(C) 56875 FOR 100, 150, 225KVA
(C) 58708 FOR 300KVA
2
V
3
W
6
U
REFER TO INSTRUCTION MANUAL FOR WIRE SIZE AND TIGHTENING TORQUE
480V
AC INPUT
480V
BYPASS INPUT
1
U
480V
AC OUTPUT
400V
BATTERY
7
V
8
W
9
N
10
U
11
V
12
W
USE COPPER CONDUCTORS ONLY !
45
-+
58708
PN 40830Incorrect fuse replacement sizemay result i n fire or inadeq uateequipment p rotecti on. Replace only with same typeand rating of fuse.CRITICAL FUSE SIZINGWARNING
(D) 40830
(E) 39561
DANGER
Turn off and lock out all power sources.
Wait at least five (5) minutes for power
to dissipate then check voltage before
servicing.
Capacitors stay charged after power
has been shut off.
Accidental contact with live parts can
cause personal injury and death.
RISK OF ELECTRIC SHOCK
39561
(F) 58705 SERIAL LABEL
®
LISTED
27E5
MFD. IN U.S.A. FR OM FOREI GN AND DOMES TIC C OMPONEN TS
HOUSTON, TEXAS
58705
®
UNINTERRUP TIBLE POWER SUP PLY
(G) 57055

GND

(I) 40831
Risk of electrical shock.PN 40831Heat sink not grounded.CAUTIONDisconnect UPS and electricallytest heat sink before touching.
(J) 57053
CAUTIONDo not turn off while opera ting.8A(control power source switch)