Toshiba 42HP95 owner manual Symptom Solution Recording problems, TV stops responding to controls

	Chapter 10: Troubleshooting
General troubleshooting (continued)
Symptom	Solution
Recording problems	¥ If you use the TVÕs remote control to start recording, you will not be able to change inputs (page 69),
	open the POP window (page 78), or open the FAV SCAN multi-window (page 80). If you attempt to do
	so, the message ÒNot Available While RecordingÓ will appear on-screen.
	¥ If you are recording a digital channel, you will only be able to change analog channels while the recording
	is in progress. If you are recording an analog channel, you will only be able to change digital channels
	while the recording is in progress. This is because the TV tuner that is being recorded (digital or analog)
	will be locked on the channel that is currently recording.
	¥ It is recommended that you use the TVÕs remote control to start recording. If you use a device other than
	the TVÕs remote control to start recording and then attempt to access a feature that is normally denied
	during recording (POP mode, FAV SCAN mode, changing inputs,) the recorded audio and/or video may
	not be what you intended to record. See pages 69 and 73.
	¥ If you connected a Symbioª AVHD recorder, in order to use its full functionality, you must first set up the
	TV Guide On Screenª system (page 24 and Chapter 5).
TV stops responding to controls	¥ If the TV stops responding to the controls on the remote control or TV side panel and you cannot turn off
	the TV, press and hold the POWER button on the TV side panel for 5 or more seconds to reset the TV.
Other problems	¥ If your TVÕs problem has not been addressed in this Troubleshooting section or the recommended
	solution has not worked, use the Restore Factory Defaults procedure as described on page 54.

		Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.	103
#01E_101-106_4250HP95	103	05.9.12, 10:11 PM
	Black

(E) 42/50HP95 *web 213:276