ICC

6.Enter the desired IP Address, Subnet Mask and Default Gateway in the appropriate boxes, then click Apply.

7.Enter the case-sensitive system password (default is “icc”) in the Authentication dialog box, then click Submit.

8.A popup dialog box will prompt you to reboot. Click Reboot. Rebooting may require 30s or more to complete. When the device status indicates “Ready”, click Close.

9.The discovery utility will automatically rescan the network. Confirm that the new IP address has been accepted by the device.

7.2 Via the Drive’s Keypad

This section applies to G9 (drive control board firmware V203R5 and later) and H9 (drive control board firmware V204R4) drives only.

The interface card’s IP Address, Subnet Mask, Default Gateway, and DHCP/Static IP mode can be viewed and modified via the drive’s keypad by navigating to Program…Communications…Ethernet Settings. Additionally, the interface card’s unique MAC ID can be viewed (but not modified) in this screen.

Note that these parameter values are read by the interface card only during initial boot-up. Therefore, be sure to power cycle the drive whenever any of these values are changed to allow the changes to take effect.

7.3 Via the Web Page

Once an initial IP address has been assigned to the device and the configuration web page can be accessed, the IP address-related parameters can also be modified via the web page. Refer to section 10.7.4.

20