ICC
10.4 Monitor Tab
10.4.1 Information Window
Figure 10 shows the Information Window, which is located in the upper- right hand corner of the monitor tab. This window displays various informational messages regarding the status of the interface card or web browser session. There is also an “activity” indicator located in the lower- right hand corner of the Information Window, which blinks periodically to
show the status of data communication between the web browser and the interface card. If you do not observe the activity indicator blink at all for several seconds or more, it is possible that the web browser may have lost contact to the web server due to a drive reset or a network problem: to reestablish communications, select “refresh” on your web browser.
10.4.2 Parameter Group Selection List
The Parameter Group Selection List is located in the
parameter group is selected, the parameter subgroups (if any) contained in that parameter group are displayed in the Parameter Subgroup Selection List (refer to section 10.4.3), and the corresponding parameters are displayed in the Parameter List (refer to section 10.4.4). The following parameter groups are available:
All: All parameters are available (configuration, command and monitor parameters).
Basic Parameters: The configuration parameters most commonly used for drive setup are available.
Extended Parameters: All other configuration parameters that are not “basic parameters” are available.
Command Parameters: Drive command parameters are available. Note that although all parameters associated with drive control are available in this selection, only those parameters that are identified as being for the “internal option board” can
26