Figure 80: I/O Configuration Tree
Figure 81: Online Module Status

ICC

Figure 79: Module Properties Connection Tab

6)After adding the I/O Module to the configuration, the full I/O Configuration tree should appear similar to Figure 80.

7)Switch to online mode and download the

project to the PLC. Verify that the newly- added drive is available and operating correctly by observing any indications shown on the drive’s icon. When the drive’s icon is selected, its status and any available error messages will be displayed in the area below the project tree. Refer to Figure 81. Also confirm that the interface card’s “Network Status” LED should be solid green, indicating an “online/connected” state.

8)By double-clicking “Controller Tags” in the project tree, it is possible to view the

newly-added tags. Refer to Figure 82. The ASD_G9ETH:C configuration tag is

unused, the ASD_G9ETH:I tag allows viewing of the input data, and the ASD_G9ETH:O tag allows modification of the output data. These tags will be synchronized with the drive at whatever rate was established for the module’s RPI.

77