L.- | . | TROUBLESHOOTING |
. | ||
|
| Remedy |
The DVC cannot be operated with this unit.
Certain functions of the unit cannot operate.
DV audio signal cannot be switched.
•Before connection, turn on the power supplies for both this unit and the DVC, and make sure that these units are in stop mode.
•Only a
•Do not connect any device other than the DVC. Even if a recorder or PC with another DV terminal is connected, the DV function will not operate.
•If the DVC is not recognized after connection, turn off the power supply for the unit and
•Signal input or DVC operation from this unit may be disabled
depending on the type of DVC.
·Ifa DVC signal cannot be input, use an external input (L1/L2) for analog connection via audio/video cables.
•DVC control may be disabled depending on the type of DVC, even in a mode other than camera mode. In this case, switch to DVD control and execute the normal recording procedure while operating the DVC.
•Some functions may not operate depending on the type of DVC. For example, if the DVC does not support slow playback mode, the slow playback function is disabled.
•With L3 (DV), the disc display menu does not appear unless disc playback is executed.
•For recording with the DVC, the recording audio signal can be set to 12 bits or 16 bits. However, when
There is no picture.
Picture noise appears.
Playback picture from the external devices connected to this unit is distorted.
There is no sound.
Sound is noisy.
The disc does not play back.
Playback image freezes for a second.
Discs recorded on this unit cannot be played back on other DVD players.
The disc does not start playback from the beginning.
The unit starts playing back the disc automatically..
Some functions such as stop, search, or
The language for the sound track cannot be changed.
·Ifthe setup menu appears on the TV screen, press [RETURN] to exit.
•Check if the progressive scan mode is set correctly according to your TV (page 94).
•Clean the disc with a cleaning cloth.
•If the picture output signal from the external devices passes through this unit to get to your TV, the copy protection signal applied to some DVD could affect the picture quality. Disconnect the playback device in question and connect it directly to your TV.
•If you are using DIGITAL AUDIO OUTPUT (COAXIAL) jack, check the setting in "Audio Out" (page 24).
•Clean the disc with a cleaning cloth.
•Clean the disc with a cleaning cloth.
•No disc is inserted.
•A blank disc is inserted.
•The disc is upside down. Insert the disc with the labeled side facing up.
•The disc is not correctly inserted.
•The unit cannot play back certain discs (such as a
•The region code on the
•Moisture has condensed inside the unit. Remove the disc and leave the unit turned on for about 2 hours until the moisture evaporates (page 4).
•If the disc was recorded on another recorder, the unit cannot play back the disc if it was not finalized.
•During the playback of 2 layered disc, picture may freeze for a moment when the 1st layer switches to the 2nd layer. This is not a malfunction.
·Ifyou are using
•Resume playback was activated (page 58). Press [STOP _] twice.
•You have inserted a disc whose title menu or DVD menu automatically appears on the TV screen when it is first inserted.
•The
•Depending on the disc, you may not be able to do some of the operations. Refer to the instruction manual supplied with the disc.
•The title does not have the multilingual audio tracks.
•The
"
1
EN 103
