Toshiba GA-1190 Monitor Volume, Alarm Volume, Reception Mode, Resolution, Receive Interval, 12TTI

10TopAccess ADMINISTRATION TAB PAGE - SETUP MENU (Printing Function)

4)Monitor Volume

Select the volume of the line monitor during transmission.

5)Alarm Volume

Selects the volume of the alarm.

6)Reception Mode

Select how this equipment activates when a fax is received.

-Auto — Select this to automatically receive incoming originals when the bell rings. Select this when the line is being used exclusively by the fax transmission.

-Manual — Select this to manually receive incoming originals after pressing the Start but- ton on the Control Panel.

7)Resolution

Select the default resolution for sending faxes.

-Standard — Select this to set the Standard mode as the default resolution appropriate for the originals in which the text is regular size.

-Fine — Select this to set the Fine mode as the default resolution appropriate for the orig- inals in which the text is small or a detailed drawing is contained.

-Ultra Fine — Select this to set the Ultra-Fine mode as the default resolution appropriate for the originals in which the text is particularly small or a precision drawing is contained.

8)Receive Interval

Selects the interval of transmissions. Transmissions are forcibly paused every 4 times to receive incoming faxes during each interval. This interval can be set from 0 to 15 minutes.

9)Redial Mode

Selects redialing intervals and the number of times to redial when the line is busy.

-Interval — Selects the redialing interval from 0 to 15 minutes.

-Counter — Selects the number of times to redial from 0 to 14.

10)Memory TX

Selects whether the fax data are temporarily stored in the memory before transmission or not.

11)Security TX

Checks whether the number you dialed matches that of a destination or not and determines whether the fax data should be transmitted or not. If these numbers do not match, the fax data will not be transmitted to prevent inadvertent data transmission caused by dialing mis- takes or misconnection of a telephone switchboard. You can select whether to enable or dis- able this function.

12)TTI

Select whether printing a transmission header (TTI) to identify the sender of received faxes.

13)RTI

Select whether printing a reception header (RTI) on received faxes to clearly identify the time, date, and page count of received faxes.

14)ECM

Select whether enabling or disabling the ECM (Error Correction Mode) to automatically re- send any portion of the document affected by phone line noise or distortion.

15)Discard

Select whether discarding the lower portion of the received fax image if it is larger than the recording paper.

16)Reduction

Select whether reducing the received fax image if it is larger than the effective printing area of the recording paper.

17)Recovery Transmit

Select whether re-transmitting a fax after failing the initially specified number of redial attempts. When this is enabled, select the stored time length from 1 to 24 hours.

102 Setting up Fax Settings