6.Slide and hold the battery release latch to disengage the battery pack and then remove it from the computer.
Figure 5-1 Releasing the battery pack (R940)
| 3 |
| 3 |
1 | 2 |
1 | 2 |
1. | Battery lock | 3. Battery pack |
2. | Battery release latch |
|
Installing the battery pack
To install a battery pack, follow the steps as detailed below:
Do not touch the battery release latch while holding the computer or the battery pack might fall out due to the unintentional release of the battery release latch and cause injuries.
1.Insert the battery pack as far as it will go into the computer.
2.Ensure that the battery pack is securely in place and the battery lock is in its locked position.
3.Turn your computer over.
Power-up modes
The computer has three different
Shut Down Mode: The computer will shut down without saving data - in view of this you must always save your work before you turn the computer off.
Hibernation Mode: Data in memory will be saved to the hard disk drive.
Sleep Mode: Data will be maintained in the computer's memory.
Please refer to the sections Turning on the power and Turning off the power in Chapter 1, Getting Started for further information.
User's Manual |
