17
Operations
English
Before Using
Preparations
Operations
Maintenance
Others

Connect the power cord.

qInsert the power cord connector into the AC IN socket on the
projector.
wInsert the power cord plug into a wall or other power outlet.
When the power cord is plugged in, the ON indicator comes on in
orange, indicating that the unit is on standby.
TEMP FANLAMPON
(Orange)
Lit

Remove the lens cover.

Be sure to remove the lens cover when the power is turned on. If it is left
on, it could become deformed due to heat.
Turning the power on and off

Before turning the power on

LCD Panels
LCD panels wear out. In order to prolong the lifetime of your LCD panel, take the following
precautions:
•In order to extend the lifetime of the LCD panel, always turn off the power when not in use, and make sure that
the lamp is off. Keeping the lamp off is also very effective at saving electricity.
•If the air filter becomes dirty and clogged, the projector’s internal temperature will rise, shortening the lifetime of
the LCD panel and causing malfunctions. Clean the air filter from time to time (see p.40), and replace it
periodically. Contact the store where you purchased your projector, or your local Service Station for replace-
ment of the air filters.
The projector’s LCD panel is made using extremely advanced technology, but there may be black
spots (pixels that do not light) or bright spots (pixels that are constantly lit) on the panel. Please
note that these are not malfunctions.
(Supplied) Power cord
connector