Maintenance
Removing the tilt stand
Do not remove the tilt stand unless when you replace the lamp or mount the projector on a ceiling. Removing the tilt stand leaves the projector unstable and may block the air intake at the bottom. Usually, the projector must be used with the tilt stand.
PRECAUTIONS
•Before removing the tilt stand, be sure to turn off the power and unplug the power cord.
English
Place the unit upside down.
Loosen the three screws.
Detach the tilt stand.
1 | 2 |
|
Turn the projector over and place it carefully. It is recommended to lay a soft cloth, such as a thick towel, under the unit to prevent it from shaking or getting scratched.
Position the tilt stand where you can see three screws in the centers of their respective screw holes. Loosen the screws by turning them counterclockwise several times.
Hold the tilt stand with both hands, turn it counterclockwise, then lift it to remove.
Maintenance Operations Preparations Before Using
To put the tilt stand back in place, take the above steps in reverse order. At this time, always make sure that the three screws have been tightened.
Others
39
