TP-Link manual Static Routing List, Archer C8, AC1750 Wireless Dual Band Gigabit Router

Models: AC1750

1 143
Download 143 pages 54.96 Kb
Page 104
Image 104
5.14.1Static Routing List

Archer C8

AC1750 Wireless Dual Band Gigabit Router

5.14.1Static Routing List

Choose menu “AdvancedAdvanced RoutingStatic Routing List”, and then you can configure the static route in the next screen (shown in Figure 5-80). A static route is a pre-determined path that network information must travel to reach a specific host or network.

Figure 5-80 Static Routing

To add static routing entries:

1.Click Add New… shown in Figure 5-80,you will see the following screen.

Figure 5-81 Add or Modify a Static Route Entry

2.Enter the following data:

Destination Network - The Destination Network is the address of the network or host that you want to assign to a static route.

Subnet Mask - The Subnet Mask determines which portion of an IP Address is the network portion, and which portion is the host portion.

Default Gateway - This is the IP Address of the gateway device that allows for contact between the router and the network or host.

3.Select Enabled or Disabled for this entry on the Status drop-down list.

4.Click the Save button to make the entry take effect.

Other configurations for the entries:

Click the Delete button to delete the entry.

Click the Enable All button to enable all the entries.

- 93 -

Page 104
Image 104
TP-Link manual Static Routing List, Archer C8, AC1750 Wireless Dual Band Gigabit Router, To add static routing entries