Trane DX1B060A9361A Installer’s Guide, Airflow, uBOTTOM ENGAGEMENT, Blower, Deck, Side, Cutout

TABLE 5

Cabinet Width	Left Side	Bottom	Right Side
14.5	X1	X2	Use Alternate Filter Clips Only
17.5	X	X	X
21	X	X	X
24.5	X	X	X

1.UD060C/R936K0 has 10x7 blower which requires use of alternate filter clips for left side filter. "K1" and later use the filter rack.

2. Remove bottom front channel to install or reposition filter rack.

X - All Models

OPTIONAL FILTER RACK INSTALLATION FOR SIDE RETURN AIR ON UPFLOW FURNACES (Left or Right)

If side air return is desired, the following instructions should be used:

a.Open or remove the blower door.

b.Leave the bottom panel in place. (Some models require field supplied bottom panels.)

c.After the side cutout is made following the directions in the “Return Air Duct Connections” section on pages 8 and 9; compress the filter rack and reinstall in the side of the furnace. Confirm that the upper retaining pin/screw locks into the engagement hole in the blower deck and the lower pin/screw rests against the side of the bottom panel. See Figures 14, 15, & 17-20.

d.Install the furnace filter on the side. See Figures 14, 15, & 17-20.

uBOTTOM ENGAGEMENT

Installer’s Guide

o	SIDE
	CUTOUT
				Airfl
				o
RETAINING				w
	PIN
(Both Sides)
	SPRINGS
			FILTER	BOTTOM
			RACK	PANEL
			RAILS	INSTALLED
Typical Upflow Left Side Return Filter Rack Installation
p				SIDE
				CUTOUT
			w
		flo
	ir
	A			RETAINING
				PIN
				(Both Sides)

Furnace

Cabinet

Side

Engagement Hole

For Filter Rack

Installation With

Bottom Return

Filter Rack

Retaining

Screw/Pin Filter

Rack

SPRINGS

BOTTOM

PANELFILTER

INSTALLED RACK

RAILS

Bottom Panel

i	Engagement Hole	Furnace
BLOWER
	Installation With	Blower
DECK	For Filter Rack
	Side Return	Deck

Typical Upflow Right Side Return Filter Rack Installation

a

Furnace

Cabinet

Side

Filter Rack	Filter
Retaining	Rack
Screw/Pin	Assembly

Airflow

Optional door kit

BAYFLTR206

Typical Horizontal Filter Installation

18-CD19D6-32 13