Tripp Lite B051-000 IP owner manual Components, Front View, Component Description, Rear View

Introduction

Components

Front View

1 2 3 4 5

No..	Component	Description
	LAN Port	The Cat5e/6 cable that connects the B051-000
1
		to a network plugs in here.
	Reset Switch	1. Pressing and releasing this switch will
2
		perform a system reset.
		2. Pressing and holding the switch for more
		than 3 seconds restores the B051-000 to its
		factory default configuration settings.
		3. Pressing and holding this switch while
		powering the unit on will restore the factory
		default firmware version. This operation
		should only be performed in the event of a
		firmware upgrade failure that results in the
		device becoming inoperable.
		Note: This switch is recessed and must be
		pushed with a thin object, such as the end of a
		paper clip or ballpoint pen.
	10/100 Mbps	This LED lights Orange to indicate a data
3
	LED	transmission speed of 10Mbps, or Green to
		indicate a Data transmission speed of 100
		Mbps.
	Link LED	This LED flashes Green to indicate that the
4
		B051-000 is being accessed remotely.
	Power LED	This LED lights Orange when the B051-000 is
5
		powered-on and ready to operate.

Rear View

1 2 3 4 5

No..	Component	Description
	Power Jack	The included power adapter connects to the unit
1
		here.
	Virtual Media	The included USB 2.0 device cable connects
2
	Port	here when using the Virtual Media feature.
	PC/KVM Port	The KVM cable kit that connects the B051-000
3
		to a KVM switch or server connects to the unit
		here.
	Console port	The console connector kit that connects a Local
4
		Console to the B051-000 connects to the unit
		here.
	RS-232 port	An RS-232 serial port is provided for out-of-
5
		band and low bandwidth modem and serial
		terminal connections.

6