Turbo Chef Technologies 2020 manual Updating the Firmware, Changing the Display Temperature

1 6 OVEN MODES

Changing the Display Temperature Info Screen

The oven can display the temperature in either Celsius or Fahrenheit units. To change the display temperature, press L1 in SETUP MODE (Figure 17).

Edit Modes Select Screen

The edit modes select screen (Figure 19) allows the user to switch between full edit, rigid, and flex for profile name, belt speed, temperature, and % air.

For more information on the different edit options, see Editing a Cooking Profile on page 11.

To access the edit modes select screen,

1.Press L3 (Figure 17) to access the password screen (Figure 18).

2.Input the password 6 6 3 3 by pressing the soft keys adjacent to the numbers.

To change the edit option (Figure 19),

-Press L1 to select full edit or rigid for the profile name.

-Press L3 to select full edit, rigid, or flex for the belt speed.

-Press R1 to select full edit, rigid, or flex for the profile cook temperature setting.

-Press R3 to select full edit, rigid, or flex for the % air setting.

Changing the Display Language

NOTE: Feature is not available on all oven models.

From the setup menu screen (Figure 17), press R1 to set the language to English, French, German, or Spanish.

The info screen (Figure 20) is used to display the following information in an easy to access place:

-Serial number

-Electrical compartment temperature

-Voltage

-Total time the oven has been on

-Total time the oven has been idle

-Firmware version

To access the info screen, press R3 within the SETUP MODE (Figure 17).

Updating the Firmware

From the oven off screen,

1.Insert the gray smart card (see Figure 14, page 15) with the gold chip facing the front of the oven. If multiple smart cards are required, they will be labeled in sequence - ensure the correct sequence is followed.

2.From the COOLING DOWN or OVEN OFF MODE,

press and hold the idle key until the oven resets (approximately 5 seconds). The display will go blank until the upload is complete.

3.When the oven beeps one long high tone, the load was successful. If a second card was provided, insert it.

4.When the oven restarts and the display turns on, the update is complete. Remove the smart card from the oven.

L1	FAULT	COUNTS	R1	L1	1		4	R1
	F1: 0	F6: 0
	F2: 0	F7: 0			ENTER PASSWORD
						<6633>
L2	F3: 0	F8: 0	R2	L2	2		5	R2
	F4: 0	F9: 0
L3	F5: 0	F10: 0	R3	L3				R3
					3		6
Figure 16: Fault Counts Screen				Figure 18: Password Screen
L1	DEGS F	ENGLISH	R1	L1	NAME: FULL		TEMP: FLEX	R1
L2	SETUP MENU		R2	L2	EDIT MODES			R2
						SELECT
L3	EDIT/RIGID/FLEX	INFO	R3	L3	BELT: RIGID		AIR: FLEX	R3

Figure 17: Setup Mode Figure 19: Edit Option Screen