Selecting Interference Eliminator Codes
Many drivers use special codes in their radios to prevent interference from other nearby radio systems. These codes are commonly referred to as CTCSS, DCS, or subaudible tones. You can use these same codes to prevent interference from other systems.
1.Press 0, rotate the scroll control to select the race, then press E.
2.Press CAR, enter the driver’s number, press E or CAR, press E, rotate the scroll control to select the driver, then press E.
3.Rotate the scroll control to select the driver’s frequency, then press E.
4.Press E to enter the channel setting menu.
5.Rotate the scroll control to select SET CTCSS/DCS, then press E.
6.Enter the correct CTCSS/DCS value, then press E.
7.Press Hold to set the selection
Selecting Systems to Scan
To select systems to scan, press Scan then press the number button corresponding to the quick key assigned to the system or systems. To stop scanning the system(s), press Scan again.
The SYS indicators on the display show the systems that are currently selected.
To select or lock out a system that is not assigned to a key, press and hold FUNC while you rotate the scroll control until the desired system is selected. Then, continue to hold FUNC and press L/O to either lock out or unlock the system.
Basic Operation
36
