Uniden SC230 owner manual Setting the Channel Delay Time, Setting Data Skip

Notes:

•If you select 0, the scanner stays on the system for a minimal time (only long enough to check current system activity).

•The default setting is 2 seconds for each system.

•All unlocked channels will be scanned at least once regardless of this setting.

•The scanner moves to the next system after the hold time expires, any current transmission ends, and the channel delay time expires.

Setting the Channel Delay Time

		program system		E
	Menu
Select the system			E
Edit		Sys Option	E
Set		DELAY Time	E

This setting controls how many seconds the scanner waits after a transmission ends before resuming scanning. Enter a value from 1-5 or Off, then press E.

Notes:

•The default setting is 2 seconds for each system.

•This setting applies to all channels within the system.

Setting Data Skip

Menu

program system E

Select the system	E
Edit Sys Option	E
Set DATA SKIP	E

This setting controls how the scanner behaves when it stops on a channel that has a data signal.

On - the scanner stops briefly on the channel, but then immediately resumes scanning automatically. Press E to select.

Off - the scanner remains on the channel until the transmission stops. Press E to select.

Programming/Editing Optional Settings

57