Uniden UBC3500XLT Turning Power Save On or Off, Priority Scan, Using the Backlight, Settings

UB347ZH.fm Page 39 Thursday, August 31, 2006 11:57 AM

Turning Power Save On or Off

Menu

Settings

Set Battery Save

•On The scanner goes into low-power mode when you monitor a conventional channel that has no activity.

•Off Power save is off.

Priority Scan

Menu

Set Priority

Or, while holding on any channel in Scan Mode, press Func + 1/pri to select one of these priority modes:

•Off Normal scanning

•On While scanning a conventional system, the scanner interrupts every 2 seconds and checks the priority channels in each unlocked conventional system. Priority channels in lower quick key numbered systems (starting from 1) have highest priority. PRI appears when you select this mode.

•Plus On The scanner only scans priority channels in unlocked conventional systems. PRI flashes when you select this mode.

Using the Backlight

Menu

Settings

	Set Backlight
•	10	sec	The backlight stays on for 10 seconds
	after you press .
•	30	sec	The backlight stays on for 30 seconds

after you press .

•Squelch The backlight turns on when the squelch opens then stays on for 5 seconds.

•Keypress The backlight turns on when any key is pressed then stays on for 10 seconds.

•Infinite The backlight turns on when you press then stays on until you press again.

Settings

39