Vermont Casting DVRT39, DVRT43 General Venting, Vermont Castings, Majestic Products DVRT36/39/43

Vermont Castings, Majestic Products DVRT36/39/43

General Venting

Your fireplace is approved to be vented either through the side wall, or vertically through the roof.

NOTE: Only venting components specifically approved and labeled for this fireplace may be used.

•Venting terminals shall not be recessed into a wall or siding.

•Horizontal venting must be installed on a level plane without any incline or decline.

•There must not be any obstructions such as bushes, garden sheds, fences, decks, or utility buildings within 24” (610mm) from the front of the termination hood.

•Do not locate the termination hood where excessive snow or ice buildup may occur.

•Be sure to check and clear the vent termination area after snow falls, to prevent accidental blockage of venting system.

•When using snow blowers, make sure snow is not directed toward the vent termination area.

Location of Vent Termination

It is imperative to observe minimum clearances (shown on the following page) when locating vent terminations.

10002428 11