Vermont Casting DVRT36 Operating Instructions, Glass Information, Louvre Removal, Glass Cleaning

Vermont Castings, Majestic Products DVRT36/39/43

Operating Instructions

Glass Information

Only glass approved by Vermont Castings, Majestic Products should be used on this fireplace.

•The use of any nonapproved replacement glass will void all product warranties.

•Care must be taken to avoid breakage of the glass.

•Do not operate appliance with glass front removed, cracked or broken.

•Replacement glass (complete with gasket) is available through your Vermont Castings, Majestic Products dealer and should be installed only by a licensed qualified service person.

Louvre Removal

Remove the louvre assembly top by lifting the panel up and out from the fireplace. (Fig. 41)

The louvre assembly bottom is hinged at the bottom edge and swings down.

2.

	Louvre
1.	Assembly Top
	Window Frame Assembly
	FP444

Fig. 41 Remove louvre assembly top.

Window Frame Assembly Removal

1.Turn the fireplace OFF (including the pilot).

2.If the unit has been operating, allow time for the components to cool.

3.Remove the louvre assembly top.

4.Open the louvre assembly bottom.

5.Release the two (2) clamps along lower edge of the frame by pulling down on clamp handles. (Fig. 42)

6.Tilt window frame assembly out slightly at the bottom, lift the frame up and away from the fireplace.

7.To replace window frame assembly, reverse this procedure.

Lower

Clamps

	Window
	Frame
Window	Assembly
Frame
Assembly	Pull Clamp
Push	Hook
Clamp
Handle
	FP1191

Fig. 42 Window frame assembly removal.

Glass Cleaning

It is necessary to periodically clean the glass panel. It is normal for condensation to form on the inside of the glass during start-up. This condensation causes lint, dust, and other airborne particles to cling to glass surface. Also, initial paint curing may deposit a slight film on the glass.

Cleaning the glass two or three times within the first few weeks of operation is recommended, using non- ammonia based household cleaner and warm water, or gas fireplace glass cleaner.

After the initial cleaning process, the glass should be cleaned two or three times during each operating season, depending on the environment in the house.

Clean the glass after the first two weeks of operation.

Do not clean glass when it is hot.

Do not use abrasive cleaners.

Do not strike or slam the glass.

10002428 25