Vermont Casting DVRT39, DVRT43 Remote Controls, Ceramic Refractory Panels, Decorative Bay Window

Vermont Castings, Majestic Products DVRT36/39/43

Remote Controls

Optional remote control units are available to control different functions of the appliance.

Model	Function(s) Controlled
MRC1	On/ Off
MRC2	On/Off and Temperature
MRC3	On/Off and Temperature control
	with digital display and programmable 24-
	hour clock
IMT	Wall-mounted Thermostat Control
	Ceramic Refractory Panels

Ceramic refractory panels are available to line the firebox area. The ceramic lining kit for the DVRT43 is supplied standard with the appliance.

Adjustable
Tab		Adjustable
		Tab
Side	Back	Side
Panel	Panel
		Panel
	Log Support
	Burner Housing
	Assy	Floor
Floor		Refracotory
		Panel
Refracotory
Panel	Lower Side
	Supports	FP1193
Fig. 60	Install ceramic refractory panels.
	Rear Refractory
	Panel

Unit	Kit Model
DVRT36	CR KIT DVT36
DVRT39	CR KIT DVT39

For installation, refer to Figures 59 and 60.

Take care when handling the refractory panels, as they are fragile until secured in place and supported.

1.	Remove the window frame assembly.
2.	Remove the logs.
3.	Place the lower supports for the side refractory
	panels on the base of the firebox. Place each

Rear Panel

Support

Brackets

Rear Log

Support

Firebox Back

FP1194

	support so that the slotted hole fits over the forward
	screw head along the edge of the base.
4.	Lay the angular base panels in place on the floor of
	the firebox on either side of the burner housing
	assembly.
5.	Loosely attach the top adjustable tabs to the
	studs located in the top of the firebox toward the
	front corners.
6.	Place the rear refractory panel in place. Locate the
	‘small brick’ edge of the panel into the two small
	supports on the back panel just above the rear
	log support.
7.	Slide the side refractory panels into place to hold
	the rear panel secure. Adjust the top adjustable
	tabs to hold the side panel against the firebox wall
	and secure the tab. Repeat the procedure on the
	other side.
8.	Replace the logs and window frame assembly.

NOTE: For aesthetic purposes, aligning the horizontal mortar lines is recommended.

Fig. 61 Place the rear panel on rear support brackets.

Decorative Bay Window

When fitting the bay window kits the original front frame/glass assembly must remain in place. The bay window kit is fitted over the existing front glass.

Bay window kits are available for the DVRT36 and DVRT39 model fireplaces.

Installation

1.Remove the existing louvre assembly bottom complete with the hinges.

2.Remove the louvre assembly top.

3.Assemble the bay window kit according to the instructions supplied with the kit.

4.Place the two pieces of ceramic refractory along the base of the bay window. (Fig. 62)

5.Hang the bay window assembly over the existing window frame assembly.

6.Reinstall the upper louvre assembly.

Do not remove the existing window frame assembly.

44 10002428