Chateau™ Decorative Gas Appliance
Fuel Conversion Instructions
WARNING! This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer’s instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in these instructions is not followed exactly, a fire, explosion or pro- duction of carbon monoxide may result causing property damage, personal injury or loss of life. The qualified service agency is responsible for the proper installation of this kit. The installation is not proper and complete until the operation of the converted appliance is checked as specified in the
manufacturer’s instructions supplied with the kit.
CAUTION: The gas supply shall be shut off prior to disconnecting the electrical power, before pro- ceeding with the conversion.
Avertissement: Cette trousse de conversion
Ne doit être installée que par le représentant d’un organisme qualifié et conformément aux instruc- tions du fabricant et aux codes et exigences pertinentes de l’autorité compétente. Quiconque ne respecte pas à la lettre les instrucitons du présent guide risque de déclencher un incendie, une explosion ou le dégagement de monoxyde de carbone entraînant des dommages matériels, des lésions corporelles ou la perte de vies humaines. L’organisme qualifié qui effectur les travaux est responsible de l’installation de cette trousse. L’installation n’est pas terminée tant que le fonc- tionnement de l’appareil converti n’a pas été vérifié selon la notice du fabricant qui accompagne la trousse.
ATTENTION: Avant d’effectuer la conversin, coupez d’abord l’limentation en gaz, ensuite, coupez l’alimentation électrique.
Conversion Precautions
Allow unit to cool if it has been operating.
Before proceeding with conversion, turn control knob on valve to OFF and turn gas supply OFF. Turn OFF any electricity that may be going to appliance.
Conversion Procedure
1.Remove glass frame. Refer to Glass Frame Assembly section on Page 22.
2.Remove lava rock, volcanic rock, embers and logs.
CAUTION: Logs may be hot.
3.With a Phillips or Robertson screwdriver, remove the four (4) screws holding the fettle to the burner assem- blies. With a 3/8” hex head, remove the two (2) hex
32
nuts holding each burner tube assembly to the base pan assembly on both sides. Remove the burner tube assemblies.
4.Remove two (2) hex nuts holding the left burner leg. Remove burner leg. (Fig. 58)
Hex
Nuts
KT550
Fig. 58 Use 3/8” socket to remove hex nuts holding burner legs.
5.Slide the burner housing assembly to the left and away.
6.Replace the four (4) injectors. Refer to Table 1.
7.Replace pilot orifice.
8.Remove pilot hood by lifting up. (Fig. 59) NOTE: It is not necessary to remove the pilot tube for conversion.
9.Remove pilot orifice with 5/32” Allen wrench. (Fig. 60)
Pilot Hood |
Pilot |
Bracket |
CO105a |
Fig. 59 Remove pilot hood. |
Index Tab | Allen Wrench |
Snap Ring |
|
| CO106a |
Fig. 60 Remove pilot orifice. |
|
| 20009543 |
