
Chateau™ Decorative Gas Appliance
Andirons
Fettle
Burner
Housing
Burner Tubes | LG291 |
Fig. 42 Ensure fettle is securely attached to the burner hous- ing and set andirons in place.
4.Place the ember material lightly, between each burner tube assembly and the burner housing, be- tween the joined burner tubes and in front over the burner tube and on top of burner tube.
NOTE: The ember material must be built up from the burner tubes to the burner housing fronts in order for the burner tubes to light properly.
Lava Rock | Ember Material |
LG423a | |
|
|
Fig. 43 Lava rock and ember placement.
5.Position the log pilot plumbing. (Fig. 44) Hold the log with the two (2) branches facing down and set it down over the pilot plumbing with the flat side of the log touching the side refractory.
6.Position the log burner overlay. (Fig. 45) The overlay is very fragile and must be handled with extra care. Hold the overlay with the flat surface facing down.
The notched corners of the overlay should be on the side of the pilot. Set the overlay on top of the burner housing and align it right to left over the burner hous- ing. Make sure the overlay fits between the two (2) fettles.
Log Pilot
Plumbing
LG424 | Pilot |
Fig. 44 Position log pilot plumbing.
Burner
Overlay
LG425
Fig. 45 Position burner overlay. Notched corners are on the pilot side.
7.Position the log grate/burner tube. (Fig. 46) Hold the log with the pointed end down and the flat surface away from you. Slide the wider end of the log at an angle in the third opening “middle” of the fettle. Hook the log on the fettle and set down over the burner tube assembly. Repeat the same procedure on the opposite side.
Log Grate/
Burner Tube
LG426
Log Grate/
Burner Tube
Fig. 46 Position the log grate/burner tube.
24 | 20009543 |