Chateau™ Decorative Gas Appliance
10.Install the conversion orifice.
11.Reinstall pilot hood. Be sure to align hood with index tab.
12.Open the control panel and remove the cover by removing two (2) screws. While holding the valve cover plate with one hand, disconnect the wiring to the switch and the pilot indicator. NOTE: Do not allow the valve cover plate to hang from the pilot wires as this could damage the wires. Remove the extension knob(s). Replace the valve regulator.
13.Using the TORX T20 bit remove and discard the three
(3)pressure regulator mounting screws (A), pressure regulator tower (B) and the spring and diaphragm as- sembly (C). (Fig. 61)
A
E
| OFF | |
| P | |
|
| I |
O | TO | L |
| ||
F
Fig. 62 Replace regulator.
D
FC108
B
C
| OFF | |
| P | |
|
| I |
NO | TO | L |
| ||
FC107
Fig. 61 Remove valve regulator.
14.Insure the rubber gasket (D) is properly positioned and install the new HI/LO pressure regulator assembly to the valve using the new screws (E) supplied with the kit. Tighten the screws securely. (Ref. torque = in/lb) (Fig. 62)
15.Install the enclosed identification label (F) to the valve body where it can easily be seen. (Fig. 62)
16.Regulator conversion complete.
17.Test for Leaks
•Apply gas to the system and light the pilot.
•With a soapy solution check for leaks around the pilot assembly where the tube enters the pilot as- sembly. Tighten fitting if necessary.
•Light the main burner and check for leaks around the new pressure regulator assembly. Tighten screws if necessary.
•With the main burner “ON” check for leaks around the burner orifice. Be careful of the burner flame. Tighten orifice if necessary.
•With the main burner “ON” rotate the HI/LO knob and verify proper burner operation.
18.Replace burner to original position.
19.Replace burner leg.
20.Replace burner tube and fettle.
21.Follow instructions on Page 23 to reinstall logs, lava rock, volcanic rock and embers.
22.Replace glass frame.
Conversion complete.
Pilot Flame Adjustment
Typically, the top 3/8” or 1/2” of the thermopile should be engulfed in the pilot flame. (Page 26, Fig. 54)
To adjust pilot burner:
1.Remove pilot adjustment cap located on valve.
2.Adjust pilot screw to provide properly sized flame.
3.Replace pilot adjustment cap.
20009543 | 33 |
