Vermont Casting SDDVRCMB, SDDVRCB manual Install the Front Plate, Thermostat Connection, 20012950

Stardance Direct Vent - Rear Vent Gas Heaters

TPTH TP TH

PILOTADJ

ST228

Fig. 49 Attach switch wires to valve.

Install the Front Plate

Grasp the Front Plate and lift it into position, engaging the two steel tabs at the upper corners behind the adja- cent bosses in the Side Plates. (Fig. 50) Seat the Front against the Sides so that the tabs at the bottom lip engage with the notches in the edge of the stove base.

When properly installed, the bottom of the Front Plate cannot be pulled away from the sides without also lifting it up.

If you are installing optional Warming Shelves, do so now, according to the instructions supplied with that kit.

Thermostat Connection

(Optional) R Models Only

Use only a thermostat rated for 500 - 750 millivolts.

Check the table below for the appropriate gauge thermostat wire to use for the length of lead required in your installation.

Thermostat
Wire / Gauge	Maximum Run
18	40 feet
20	25 feet
22	16 feet

1.Install the wall thermostat in the desired location and run the wires to the stove location. Terminate these leads with 1/4” female connectors.

2.Connect the thermostat wires to the valve. (Fig. 49)

This completes assembly of the Stardance Rear Vent stove.

Bottom Tabs

Engage Notch in

Base ST940

Fig. 50 Install Stove Front.

28 20012950