Vermont Casting SDDVRCEB, SDDVRCMB Selkirk venting components, Offsets, 20012950, Offset support

Vent Termina- tion (VC)

Storm Collar (SC)

Roof Flash- ing (AF)

Ceiling Support (CS)

Trim Plate (TP)

Pipe Length

Pipe Length

90° Elbow (EL90)

Appliance Adapter (AAV)

Fig. 39 Selkirk venting components.

Trim Plate (TP) (Required if Wall Thimble is not used)

Horizontal Ter- mination (HC)

Wall Thimble (WT) (Optional)

Stardance Direct Vent - Rear Vent Gas Heaters

A two-part square trim plate is provided to give a fin- ished look once installed. Simply fit the two halves of the trim plate around the cathedral ceiling support box hanging below the ceiling (overlapping if necessary) and screw them to the ceiling. Both the ceiling support and cathedral ceiling support can support a maximum of 40’ (12 m) of pipe.

Offsets:

If any offsets are necessary in the vertical system, an Offset Support (OS) should be installed directly above the upper elbow of the offset. Install by attaching the offset support band to the pipe with two #8 x 1/4” sheet metal screws (minimum ) and secure the offset support straps to surrounding structure. (Fig. 40)

	Nail to top of
	framing
Offset Support	Offset Support
Strap	Collar

ST927

Fig. 40 Offset support.

ST945

Appliance

Adapter (AAV)

Pipe

Length

ST946

20012950 23