www.vxitech.com
GENERAL SAFETY INSTRUCTIONS
Review the following safety precautions to avoid bodily injury and/or damage to the product. These precautions must be observed during all phases of operation or service of this product. Failure to comply with these precautions, or with specific warnings elsewhere in this manual, violates safety standards of design, manufacture, and intended use of the product.
Service should only be performed by qualified personnel.
TERMS AND SYMBOLS
These terms may appear in this manual:
WARNING | Indicates that a procedure or condition may cause bodily injury or death. |
CAUTION | Indicates that a procedure or condition could possibly cause damage to |
| equipment or loss of data. |
These symbols may appear on the product:
ATTENTION - Important safety instructions
Frame or chassis ground
Indicates that the product was manufactured after August 13, 2005. This mark is placed in accordance with EN 50419, Marking of electrical and electronic equipment in accordance with Article 11(2) of Directive 2002/96/EC (WEEE).
WARNINGS
Follow these precautions to avoid injury or damage to the product:
Use Proper Power Source | To avoid electrical overload, electric shock, or fire hazard, do not | |
Operating Conditions | use a power source that applies other than the specified voltage. | |
To avoid injury, electric shock or fire hazard: | ||
| - | Do not operate in wet or damp conditions. |
| - | Do not operate in an explosive atmosphere. |
| - | Operate or store only in specified temperature range. |
| - | Provide proper clearance for product ventilation to prevent |
|
| overheating. |
| - | DO NOT operate if any damage to this product is suspected. |
|
| Product should be inspected or serviced only by qualified |
Improper Use |
| personnel. |
The operator of this instrument is advised that if the equipment is | ||
| used in a manner not specified in this manual, the protection | |
provided by the equipment may be impaired. Conformity is checked by inspection.
EX7000 Series Preface | 7 |
