VXI EX7000 user manual Device Identify, Upgrade

www.vxitech.com

NOTE	Specifying SNTP or NTP servers by hostname requires that the instrument be configured for DNS,
	either by DHCP or Static IP.

DEVICE IDENTIFY

This action page is used to identify the EX7000 that is being commanded in the current session. When the “Turn on” button is pressed, the LAN LED located on the rear panel of the EX7000 will blink. When the “Turn off” button is pressed, the LAN LED returns to its normal operation.

FIGURE 4-9: DEVICE IDENTIFY WEB PAGE

UPGRADE

	This action page is used to upgrade the embedded firmware of the EX7000. Prior to initiating the
	firmware upgrade process, a new, uncompressed firmware image must be obtained from
	VXI Technology and be accessible from the computer that is connected to the EX7000. Unless
	specifically noted by VXI Technology, firmware upgrades do not alter the non-volatile
	configuration settings (network configuration, time configuration) of the EX7000.
NOTE	Do not power cycle the EX7000 during the firmware upgrade process. If power is lost during the
	upgrade, the instrument may be put into an inoperable state, requiring return to the factory. An
	uninterruptible power supply may be used to avoid this risk.

EX7000 Series Web Page Operation 33