FOR THE OPERATOR

PRIOR TO ENTRIES

1Preparations for entries

Before registrations, insert the operator key into the mode switch and turn it to the REG position and check the following items:

Paper roll

If the paper roll is not set in the machine or there is low roll, install new one according to section “4. Installing and removing the paper roll” under “OPERATOR MAINTENANCE.”

Bill separator

A bill separator is set in a drawer. When necessary, use the separator so that you can treat two kinds of bills in a bill case.

Receipt ON/OFF function

When you use the printer to issue receipts, you can disable receipt printing in the REG mode to save paper using the receipt function. To disable receipt printing, press the Ükey in the OP X/Z position. This key toggles the receipt printing status ON and OFF.

To check the receipt printing status, turn the mode switch to the OP X/Z position or press the ckey in the REG mode. When the function is in the OFF status, the receipt off indicator “_” illuminates. Your register will print reports regardless of the receipt state, so the paper roll must be installed even when the receipt state is “OFF”.

Cashier assignment

Prior to any item entries, cashiers must enter their cashier codes into the register. However, the code entry may not be necessary when the same cashier handles the next transaction.

Cashier code

Cashier name

Sign-on

 

 

Sign-off

 

 

To display the signed-on cashier code

 

 

 

 

 

 

 

 

 

Cashier code

 

 

 

 

 

 

 

 

 

 

2Power saving mode

When the time which is programmed has passed under the condition that no entry nor operation is performed, your register will enter the power saving mode.

When your register goes to the power saving mode, it will light off all the display except the decimal point at the leftmost position. Your register will return to the normal operation mode when any key is pressed or a mode is changed with the mode key. However, please note that when your register is recovered by a key entry, its key entry is invalid. So, after the recovery, start the key entry from the beginning.

40

Page 42
Image 42
Weider ER-A220 instruction manual Prior to Entries, Preparations for entries, Power saving mode