Woodstock W1770 manual Fence, Guide Post Handwheel, To install the fence, do these steps

W1770 21" Bandsaw w/Foot Brake

Fence

The fence rail is installed upside down at the factory.

To install the fence, do these steps:

1.Remove the cap screws holding the rail onto the table, and remove the rail.

2.Flip the rail over and reinstall it with the cap screws removed in Step 1 (see Figure 14).

3.Place the fence on the rail (Figure 15) and tighten it securely with the hand knob. Refer to the instruc- tions on Page 29 to calibrate the pointer.

Figure 14. Tightening guard rail cap

screws.

SETUP

Guide Post Handwheel

Insert the guide post handwheel onto the shaft, and secure it with the cap screw on the flat of the shaft, as shown in Figure 16.

-16-

Figure 15. Installing fence onto rail.

Handle

Figure 16. Guide post handwheel

installed.