Installation

Mounting the ACCB to the Inverter

Important: Ensure that the factory installed cables in the ACCB are not pinched, crushed, removed, or damaged during the installation to the inverter.

To install the ACCB on the inverter:

1.Mount the inverter into place, either wall-mounted or shelf-mounted, and secure with appropriate lag bolts. See the Sine Wave Plus Inverter/Charger Owner’s Manual for specific mounting instructions for the inverter.

2.Line up the ACCB at the AC end of the inverter, so that the mounting rails are aligned together and the ACCB base is as close to the inverter as possible. The gap between the ACCB and the inverter should be no more than 1/16 inch.

3.Secure the ACCB in place with six #10 wood screws of an appropriate length (or lag bolts) in the six mounting and keyhole slots on the mounting rails of the ACCB.

4.Leave the top cover off the ACCB to proceed with wire connections.

Mounting holes and keyhole slots for ACCB

ACCB Base with top cover removed

D

D

Mounting holes and keyhole slots for ACCB

Mounting Rails

Set Inverter

OFFSRCH ONCHG

Sine Wave Plus Inverter / Charger

Sine Wave Plus Inverter/Charger

Figure 1-10Installing the ACCB on the Sine Wave Plus Inverter Charger

1–14

975-0046-01-01