Installation

Installing the Safety Plate

The purpose of the Safety Plate (SP-1) is to prevent accidental contact with any live circuits or wires within the AC Conduit Box. The Safety Plate only needs to be installed in the event that the Sine Wave Plus is removed. The Safety Plate (SP-1) covers the open end of AC Conduit Box on the inverter side. It attaches to the base of the conduit box and is secured by the Sems screws that attach the top cover.

WARNING: Shock Hazard

Be sure to disconnect all DC and AC power before removing the inverter and installing the safety plate.

To install the safety plate:

3.Remove the two #8 Sems screws on the top and bottom of the ACCB. Put these screws is a safe place.

4.Slide the safety plate over the open end of the conduit box inserting the cover tabs into the slots on the safety plate. Be sure to align the holes for the screws for resecuring the top cover.

5.Replace the two #8 Sems screws on the top and bottom of the chassis to secure the Safety Plate into place.

Remove these 2

#8 Sems Screws only

Cover Tabs

Inverter side

of ACCB

Figure 1-35Removing the Sems Screws From the ACCB Top Cover

1–40

975-0046-01-01