Xantrex Technology Freedom SW Series manual Configuration Steps

Log in - see “Logging In”

Configuration

Configuration Steps

To complete Conext ComBox setup, you must successfully complete the procedures in Chapter 2, “Installation”. Make sure the Conext ComBox is connected, the Power LED is on, and the Status LED is off. Your Xanbus devices should still be in standby mode.

When you log in to the web interface, most of the setup information appears automatically with their default values. Some information requires change (such as passwords), some information can be modified as needed, and some information can only be modified by a qualified IT professional.

The following items are part of the Conext ComBox configuration process:

Primaryp

pChange the password - see “Changing the Admin Password”

pSet the time - see “Changing the Time”

pEnter e-mail information - see “Changing E-Mail Settings” and sending reports - see “E-mail Reporting”

pConnect the Conext ComBox to the Xanbus network - see “Connecting the Conext ComBox to the Xanbus Network”

pConfigure basic ComBox settings in the control panel- see “Changing Basic Conext ComBox Settings”

Secondary	p Change TCP/IP settings if you want to use static IP addresses - see “TCP/IP
	Settings”
	p Configure Conext ComBox settings - see “Changing Advanced Conext
	ComBox Settings”
Optional/	p Clear the device memory - see “Clearing the Internal Firmware Memory”
Occasional	p Upgrade the device firmware - see “Upgrading Firmware”

3–2 975-0704-01-01 Revision A