|
|
| Changing Advanced Conext ComBox Settings | |
|
| |||
Changing the | The default Device Friendly Name is the device’s serial number assigned at the | |||
device name | factory. It is good practice to change this default to a | |||
| To change the device name: |
| ||
| 1. | Replace the default value using alphanumeric characters. | ||
| 2. | Click | to save the setting. |
|
| 3. | To recall the previous value, click | . | |
Rebooting the | You can reboot the Conext ComBox unit from the web user interface without | |||
Conext ComBox | doing a power cycle. This type of “soft” rebooting is oftentimes necessary when | |||
| certain settings are changed, like changing the Xanbus Bit Rate parameter. |
To reboot the Conext ComBox:
1.Click the button. A Warning dialog box appears.
2.Click the OK button on the Warning dialog box.
3.To discontinue rebooting, click the Cancel button on the Warning dialog box.
Shutting down the You should shut down the Conext ComBox unit from the web user interface.
Conext ComBox Shutting down is equivalent to turning off the unit, usually for preparing to store the unit away or to reinstall the unit at a different location.
Note: Do not shut down by abruptly disconnecting all power sources to the Conext ComBox without following the procedure below. An abrupt disconnection may result in data corruption.
To shut down the Conext ComBox:
1.Click the button. A Warning dialog box appears.
2.Click the OK button on the Warning dialog box.
3.To discontinue shutting down, click the Cancel button on the Warning dialog box.
Change User Password Settings
The Change User Password setting applies only to the Conext ComBox user account.